Joeyguru69

The 3.6 liter dodge journey awd crankshaft positioning sensor is in the bottom of the block behind the engine where the transfer case is. There’s no room to get to it even if you remove the shield and everything.and even if you can get the bolt off the 10mm for the sensor then it’s to long to pull out cause the transfer case is in the way. There’s barely any room. So you have to take the transfer case off to change the crank position sensor. And if you look in the middle of the transfer case and engine block underneath the journey it’s literally between them going into the engine right behind the flywheel in between the transfer case and engine. So take the transfer case off and you’re good to go. The internet doesn’t really have videos showing the best things to do cause I searched everything and there all for the 2.4 ones not the 3.6 and half the videos are blotchy and doesn’t show you anything really. I know cause I just did mine and it’s a pain to do it’s not like some other cars that are simple to get to cause you HAVE to remove the transfer case and then you have full access to it