2late4u

i dont have awd but my daughter is a rural mail carrier and with the jeeps if they have mismatched tires it CAN set off the warning buzzer .do what you want...we can only give suggestions..its not how level the road is it is one wheel on the same axle traveling at a different revolution than the other tire. at ;east that is what was told to me by the jeep dealership.

had mine done yesterday morning took about 30 mins, i checked all my electronic settings before taking it in and checked everything after wards, every thing still working like they should. actually almost wasn't going to have it done but the wife put the end to that, lol then afterward ran it down and had my alignment checked and was golden there so Monday we are off to Biloix Ms for a little gambling and drinking what a way to enjoy life.....

Armando know how you feel just had my recall done today, wasn't going to bother with it but the wife insisted on having it done, but no problems only took about 20-30 minutes.

havent heard of this before you should make a report on it to the safety dept thur the government. i dont believe they will do anything unless their are a lot of reports for the same thing. good luck

have the battery checked first.most auto stores do it for free, agree with larryl the gauges always act crazy with a low battery.

well has any one had the recall done?????? just got mine in the mail today,

i have never had much luck with mopar batteries, What was the problem with the rear suspension and what part went bad not a lot of miles for problems there already?

have been seeing it on facebook, not in my playbook reg cleaning and wax is good enough for me..

not good with uploading pics, just somewhere towards the front and about in the middle feel behind the metal seat bracket for any wires and drill a small hole then add a small black headed screw. i did it kind of close to the bracket that attached the plastic cover to the metal seat bracket to give it more strength so it wouldn't break again and it hasn't....

didnt replace mine but if and when you get it replaced YOU had better drill and run a screw thur the plastic to secure it to the metal frame or not to far down the road you will be doing it again....

i have a small indent in the headliner where the cord from the small black box is glued to, that is the only indent i see but where the bigger plastic cover from the rear view mirror is held on goes all the way to the top of the liner and i cant see if there is a indent there or not.

putting in a separate horn button isn't hard did it for my daughters right hand drive conversion on her old jeep, they have a small wiring kit and button just make sure you use a inline fuse on the wiring . check with any parts store or amazon i would expect to have one...

are you saying the journey is running fine now ,,except it is showing the codes? if so just use it as is and see if the codes will go away after some use................. .also i believe the 2.4 uses the copper plugs not the ones you used...keep us informed on what happens.

check you tube on videos, remove and check for loose connections and or buy a replacement

as in my previous post i did reorder the kawell lights and installed as i said above and ran the wires to my back up lights.... i have enough light now, works great and yea you can see the 6 inch led light screwed onto of the red reflector but it doesn't look all that bad, for the price i like them a lot..

so what was your problem prior to wanting to remove the pdc and did this and cleaning what seems to be some corrosion that is shown? just seen your second post, so i guess this fixed your shifting problem,,,, great job and yes you should make a u tube video wouldn't take you very long and it would be make you famous....

change out the heater core as suggested by the dealership . pay them $$$ or check out you tube for a simple way to change it out yourself or have your local mechanic watch it for a cheaper way to do it$.

i just replaced my brakes all 4 corners on my 2014 crossroad and i have about 74 k on it , i had already bought the wagner thermoquite pads and when i removed the pads i was surprised as to how much pad was left, look like about half of the pads were still there . went ahead and changed them all out, the rears looked more worn then the fronts.guess i would have got at least 100 k on them but was half way there so done them all....

oh well havent had any problems so far guess i wait for the letter.....LOL

Fiat Chrysler recalls 4.8 million vehicles, shares fall Fiat Chrysler is warning the owners of about 4.8 million vehicles to stop using the cruise control immediately. A potential defect could leave the driver unable to cancel cruise control during certain circumstances. Drivers should not use cruise control until the vehicles have been inspected. The recall is one of the largest ever issued in the U.S. Phil LeBeau | @Lebeaucarnews Published 24 Mins Ago Updated 2 Mins AgoCNBC.com Source: Fiat Chrysler 2018 Jeep Wrangler Fiat Chrysler is warning the owners of approximately 4.8 million vehicles to stop using the cruise control immediately due a potential defect that could leave the driver unable to cancel cruise control during certain circumstances. The recall is one of the largest ever issued in the U.S. It covers 14 Jeep, Ram, Chrysler and Dodge models built between 2014 and 2018. The automaker says it knows of no accidents, injuries or fatalities caused by the defect. In premarket trading Friday, Fiat Chrysler shares fell about 2.5 percent. The warning to stop using cruise control comes as more than 36 million people get ready to hit the road for the long holiday weekend. Many are likely to be in Fiat Chrysler models covered by the warning and recall. Fiat Chrysler says if drivers are unable to cancel cruise control, they can eventually stop the vehicle by shifting it into neutral and braking. Once the vehicle has stopped, drivers must put it in park in order to cancel the cruise-control engagement. The automaker is planning to fix the defect with a software update. FCA says it will soon start notifying owners when they should bring their vehicles into dealerships for the repair. The following models are affected: 2015-17 Chrysler 200 sedan 2014-18 Chrysler 300 sedan 2017-18 Chrysler Pacifica minivan 2015-18 Dodge Challenger coupe 2014-18 Dodge Charger sedan 2014-18 Dodge Journey CUV 2014-18 Dodge Durango SUV 2014-18 Jeep Cherokee SUV 2014-18 Jeep Grand Cherokee SUV 2018 Jeep Wrangler 2014-19 Ram 1500 pickup 2014-18 Ram 2500 pickup 2014-18 Ram 3500 pickup 2014-18 Ram 3500 cab chassis

nope the one time mine told me to check the gas cap, it reset itself. maybe your cap is still leaking pressure?

i had a 2011 and loved it traded it in with 70 k on it for my 2014 and love it and i now have about 74 k on this one, now can it give you problems yes and no just depends on how it has been treated before you buy it, personally i think you will like it, also we dont have diesels here so not sure what you are looking at either gas or diesel in all city friving the 3.6 doesnt get real great mpg but that is that good luck.

at least he not asking for us to put a down payment for him...

so have you switched to the full sny fuild instead of replacing hoses, also instead of replacing with oem hoes go to your local hyd hose shop and have some good ones made up, shouldn't be to expensive and save the aggravation of replacing them.

yep he should have went with the copper plugs that are oem......he will be posting down the line.