2late4u
Journey Member-
Posts
4,621 -
Joined
-
Last visited
-
Days Won
480
Content Type
Profiles
Forums
Gallery
Everything posted by 2late4u
-
Losing voltage when temps are below freezing.
2late4u replied to MartyZ1's topic in Electrical, Battery & Charging
Well it is 2 yrs old first i would get it load checked and also have the alt checked to make sure it is producing what it should, (BETTER to know it is good than to think it is good)then i would take the time to remove the cables off the battery and clean then and the post real good and then reattach them tight and then also spray some corrosion spray to the terminals and then go from there,also check the grounds up at the jump terminals to make sure they are clean and tight also the starter and frame as well. all this is free and just makes good sense take some steps, before chasing other thoughts as to what is happening -
well you could remove the window control panel from the door and test to see if you got power to the switch ,I would guess the motor for the window has went bad, the wires going thur the door frame to the door in the the rubber boot are know to be a problem area for broken or frayed wires that might be a problem.,,,good luck and welcome to the group
-
2014 Dodge Journey Oil Filter Housing
2late4u replied to RebelPanda's topic in Engine & Transmission
i hope you try to get a refund on the defective unit....- 13 replies
-
- journey
- oilfilterhousing
-
(and 2 more)
Tagged with:
-
TrueDrive 2014 Dodge Journey - Wheel Hub and Bearing - Front, Driver or Passenger Side, AWD/FWD +5 Hover over main image to zoom $61.99
-
actually the tone ring is built onto the cv axle at on all i have ever seen as it spins around ,the abs wire sensor pickup sends the signal to the computer. i am sure that is how it has on journeys as well, that said your wheel bearing as well could be going bad and that as well can cause a wheel speed sensor to show as bad depending on how many miles you have on your journey.....here is a link showing replacing a tone ring,,( i didnt even know it could be replaced but for the trouble and cpost a new cv axle would be the quicker and easier solution as well)
-
3.6l Pentastar Oil filter plug instead of Bypass Valve + oil mix
2late4u replied to djdan_23's topic in Engine & Transmission
yes when you google your 2013 journey 3.6 oil filter it will bring up pictures of this design 2011-1013 -
local auto zone dig, my daughter's jeep and said which wheel speed sensor with their code reader....dont see where you are located Kieran
-
from a dodge dealership up in michigan over the internet,,,,mine doesn't cover batteries or wear items.....and yes the 09 came with the lifetime warranty as they were trying to assure everyone that chrysler was going to stay in business,,,,,,if you check on it i know if my repair cost more than what the car is worth they will only cover up to that and the rest is on me and then they can void the warranty. and yes also dodge doesn't offer this max warranty any more
-
use a code reader and or go to your local car part store they usually will read the codes and be able to tell you what MIGHT be wrong otherwise you are just guessing...yes with thoes lights on it is usually a wheel speed sensor and fairly easy to replace and not very expensive, that said not sure on the awd light as i dont have awd but they do need to be serviced at certain intervals,,,but on mine the abs light and traction control light and came on when it was a speed sensor..........you could just remove each wheel and right behind the hub is a bolt that holds the sensor in the hole just remove it and wipe it off DONT use any brake cleaner on it and make sure everything looks clean and then reinstall the sensor and bolt....my daughters jeep patriot light came on and there was some trash in the hole blocking the sensor from activating the signal to the main computer,I cleaned it off and drove it a few miles light went off and no more problems
-
i also had never thought much of the ext warranties myself but after having my 2011 70 k with no big prob, i traded it in on my 2014 and ended up buying the lifetime warranty on it over the internet cost me $2200 for it, LOL my local dealership wouldn't even sell the lifetime one, as i really liked the style of the journey. I have had to use it 2 times so far nothing real big both visit would have cost me over (1k together) but only had to pay 100 each visit so around 800 so i am still in the hole for a while which is fine with me....LOL
-
2014 Dodge Journey Oil Filter Housing
2late4u replied to RebelPanda's topic in Engine & Transmission
agree with john , i would say the part is defective if you have tried 2 different times with new seal,,,,,,,,,,,,,,,,,,,,,,,,,,,,where did you purchase it?????????- 13 replies
-
- journey
- oilfilterhousing
-
(and 2 more)
Tagged with:
-
there are 2 different oil filters for the 3.6 , also change your own oil as most places will over tighten the oil cap and can crack the housing, it uses a o ring to seal
-
do what does the info system tell you what the engine coolant temperature is? should be around 195 -203 after fully warmed up, probally the state is sticking open i am surprised you dont have a engine light due to you saying it is around 70 according to your scanner,,,as i mentioned i would install a new thermostat
-
so which eng? check the records on the maintenance that has been done on it? if 3.6 eng won't be long for the plugs and transmission service along with the coolant service as well and these services are not cheap, 2.4 eng plugs are very easy and cheap to change...journey probally won't ride as well but i have had a 2011 which i traded in on with 70 k for my 2014 crossroad 122 k on it now , both had the 3.6 eng i really love my journey
-
pretty much
-
i use this brand, i like them as they are like a carpet fiber and fit the journey front like a glove,,they also come in a plastic or rubber compound for you all that want a weather proof brand,,,,,,,,,also if you have to give them measurements then they are not a very good company........ 3D MAXpider L1DG01212209 Front Row Custom Fit Floor Mat for Select Dodge Journey Models - Classic Carpet (Black) Visit the 3D MAXpider Store 4.3 out of 5 stars 20 ratings $70.78
- 1 reply
-
- interior
- floor mats
-
(and 2 more)
Tagged with:
-
were the battery post cleaned and tightened properly ? also check the ground in the upper part of the fender, clean it off good and make sure the other grounds on the car as well, ? reason i am saying this as all the symptoms point to a weak or bad battery or lack of a strong current as the electronics go crazy with a bad battery, hopefully some else will chime in with better advice.good luck
-
i think you are confusing that engine with the 3.6 that does route coolant thur the oil cooler, that said his response to adding oil but that wasnt the problem then notices coolant tank empty then refills it then it is low again after driving and sees it leaking he needs to take it to a qualified garage for a diagnostic and repair
-
ECS / TCS coming on how to diagnose?
2late4u replied to aviator79's topic in Electrical, Battery & Charging
just fixed my daughters patriot tonight the abs, 4 wheel drive,esp lights came on couple days ago she had a bad rubber boot on her LF cv axle rot away so she had it replaced just a couple of days ago, so she got had it scanned at auto zone and it came up as L F speed sensor just like i thought it would be,so I removed the tire and removed the bolt holding the sensor in and it was covered in thick road grease and grime ,cleaned it off put everything back together again, took it for a drive and everything is fine again -
so what was the problem?
-
What causes a P0303 code? Code P0303 Causes Cylinder 3 misfires can be caused by many reasons from a faulty ignition system, fuel system, or internal engine failure. The most common reason for this to happen is faulty or worn-out spark plug coil packs, especially if it's been a while since you had a tune-up.
-
if you have a 3.6 it uses a 203 degree stat. normal temp should be between 195 to 210 IF your rad fan is working properly