SteveFromNJ Posted June 20, 2021 Report Share Posted June 20, 2021 In my infinite wisdom I did not make a diagram prior to removing my 2013 Journey's driver's seat to replace the adjuster which had 2 cracked welds. Now I cannot remember where the connector from the seat back- I'm assuming it's for the air bag/SRS- goes into. It's a manual, non-heated seat. Anyone have any ideas? I tried looking at the passenger side but I can't see well over there. Thanks, all. Quote Link to comment Share on other sites More sharing options...
John/Horace Posted June 20, 2021 Report Share Posted June 20, 2021 Air bag stuff is usually bright yellow wire loom. I usually unhook battery for 15 mins before starting. Looking where the clips snap into metal brackets every 6 inches or so is often helpful. Its hard with seat installed to take useful pics. This is a heated seat car pic. wires run along side closer to passenger I think, behind plastic cover. Quote Link to comment Share on other sites More sharing options...
2late4u Posted June 24, 2021 Report Share Posted June 24, 2021 1 hour ago, Locosiete said: Under your seats are pretty clean. Guessing you don't have any young children otherwise the lack of fries is amazing lol isn't it amazing as well, they never rot, turn green, or melt away Locosiete 1 Quote Link to comment Share on other sites More sharing options...
John/Horace Posted June 24, 2021 Report Share Posted June 24, 2021 Never any young kids in my wife’s Journey in pic. The carpets do have some salt stains in the front. Daughter in laws Journey is a different story, tumble weeds of dog hair. Baby stuff every where. I assume the OP figured out his route for wiring. Locosiete 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.