Jump to content

Finding TDC help (2014 3.6 awd)


Recommended Posts

So I have 3 camshafts in "time", with my marks lining back up at the 12 o'clock marks I marked with my paint pen when the engine was at TDC but I have 1 cam that's not at 12 it's more at the 9 o'clock position

 

So...

Front set of cams are in time and at the 12 oclock position, the rear set has the intake cam in time at 12 but the exhast cam is at 9

 

Question:

Can I remove the chain from the cam out of "time" keep the cam bolted in place and manually rotate the cam itself to where the paint marks I made are back lined up with the other cams?  (I have the tooth on the cam marked and the chain link marked) than reconnect the chain and will it than be back in time? 

 

 

Link to comment
Share on other sites

Lots of mechanics because of all the timing belt engines still paint mark their chains. If the paint marks line up again you should be fine. Always do another 720 degrees or two rotations again after you make marks line up. To make sure nothing has shifted, even after an adjustment. One tooth can be over 8 degrees and car won’t run right.

 

Edited by John/Horace
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...