bfurth Posted May 6, 2015 Report Share Posted May 6, 2015 I tend not to have to drive my DJ at night too often, so it took a while to notice this. After a collision in March, my driver side headlight had to be replaced. Now the aim seems like it's off. The body shop SHOULD have set it, but that doesn't mean they did it exactly correct. Does anyone have the correct aiming points? Also, where are the adjustment screws located? Quote Link to comment Share on other sites More sharing options...
bfurth Posted May 9, 2015 Author Report Share Posted May 9, 2015 (edited) Turned out to be easier than I was hoping. The passenger light was still factory aimed, so it was a good reference point. When I parked it in my driveway, it lined up perfectly with a panel on the garage door. There is a 12mm bolt head on the back side of each headlight assembly. A 1/4" drive socket fits in perfectly. Edited May 10, 2015 by bfurth dhh3 1 Quote Link to comment Share on other sites More sharing options...
Lobitz68 Posted May 13, 2015 Report Share Posted May 13, 2015 Keep in mind that you should be about 25' from the surface you are using to aim them. Closer will result in a much more dramatic change that it would appear had been made. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.